(Georgia Institute of Technology, 2006-05)
Kim, Dong Seop; Meemongkolkiat, Vichai; Ebong, Abasifreke; Rounsaville, Brian; Upadhyaya, V.; Das, A.; Rohatgi, Ajeet
Two-dimensional numerical simulations were performed to derive design rules for low-cost, high-efficiency interdigitated back contact (IBC) solar cells on a low-cost
substrate. The IBC solar cells were designed to be fabricated using either the conventional screen printing or
photolithography metallization processes. Bulk lifetime, bulk resistivity, contact spacing (pitch), contact opening width, recombination in the gap between the p(+) BSF and n(+) emitter, and the ratio of emitter width to pitch have been used as key variables in the simulations. It is found that short circuit current density (J(sc)) is not only a strong function of the bulk lifetime but also the emitter coverage
of the rear surface. Fill factor (FF) decreases as the emitter coverage increases because the majority carriers need to travel a longer distance through the substrate for
longer emitter width. The simulated IBC results were compared with those for conventional screen printed solar cells. It was found that the IBC solar cell outperforms the screen printed (SP) solar cell when the bulk lifetime is above 50 μs due to higher V(oc) and J(sc), which suggests that higher performance can be realized on low-cost substrates with the IBC structure.
(Georgia Institute of Technology, 2005-10)
Rohatgi, Ajeet; Ebong, Abasifreke; Hilali, Mohamed M.; Meemongkolkiat, Vichai; Rounsaville, Brian; Ristow, Alan
In this paper we report on high efficiency screen-printed 4 cm(2) solar cells fabricated on randomly textured float zone, magnetic Czochralski (MCz) and Ga-doped Cz silicon. A simple process involving POCl(3) emitters, low frequency PECVD silicon nitride deposition, Al back contact print, Ag front grid print followed by co-firing of the contacts produced efficiencies of 19.0% on textured float zone, 18.2% on MCz and 17.7% on Ga-doped Cz. A combination of high sheet resistance emitter (~100 Ω-/sq.) and the surface texturing resulted in short circuit current density of 37.3 mA/cm(2) for 0.6 Ω-cm float zone cell, 38.2 mA/cm(2) for 4.8 Ω-cm MCz cell and 37.4 mA/cm(2) for 1.5 Ω-cm Ga-doped Cz cell. Open circuit voltages were consistent with the base resistivity of the three materials. However, FF was highest for float zone (0.784) followed by MCz (0.759) and Ga-doped Cz (0.754). Model calculations performed using PC1D showed that, once the lifetime exceeds 200 μs for this cell design, the efficiency no longer has a strong dependence on the bulk lifetime. Instead, the performance is limited by the cell design including contacts, base resistivity, doping profiles, and front and back surface recombination velocities. Detailed analysis is performed to explain the high performance of these screen-printed cells and guidelines are provided for ≥20% efficient screen-printed cells.