(Georgia Institute of Technology, 2012-11-14)
Aguilar, Jeffrey Jose
We study vertical jumping in a simple robot comprising an actuated mass spring arrangement. The actuator frequency and phase are systematically varied to find optimal performance. Optimal jumps occur above and below (but not at) the robot's resonant frequency f0. Two distinct jumping modes emerge: a simple jump which is optimal above f0 is achievable with a squat maneuver, and a peculiar stutter jump which is optimal below f0 is generated with a countermovement. A simple dynamical model reveals how optimal lift-off results from non-resonant transient dynamics.
(Georgia Institute of Technology, 2012-04-06)
Henderson, Gregory Clark
A control method is proposed for exercising specific muscles of a human's lower body. This is accomplished using an exoskeleton that imposes active force feedback control. The proposed method involves a combined dynamic model of the musculoskeletal system of the lower-body with the dynamics of pneumatic actuators. The exoskeleton is designed to allow for individual control of mono-articular or bi-articular muscles to be exercised while not inhibiting the subject's range of motion.
The control method has been implemented in a 1-Degree of Freedom (DOF) exoskeleton that is designed to resist the motion of the human knee by applying actuator forces in opposition to a specified muscle force profile. In this research, there is a discussion on the model of the human's lower body and how muscles are affected as a function of joint positions. Then it is discussed how to calculate for the forces needed by a pneumatic actuator to oppose the muscles to create the desired muscle force profile at a given joint angles. The proposed exoskeleton could be utilized either for rehabilitation purposes, to prevent muscle atrophy and bone loss of astronauts, or for muscle training in general.
(Georgia Institute of Technology, 2011-11-18)
Daepp, Hannes Gorkin
Successful development of mechatronic systems requires a combination of targeted hardware and software design. The compact rescue robot (CRR), a quadruped pneumatically-actuated walking robot that seeks to use the benefits garnered from pneumatic power, is a prime example of such a system. This thesis discusses the development and testing of a simulation that will aid in further design and development of the CRR by enabling users to examine the impacts of pneumatic actuation on a walking robot. However, development of an entirely new dynamic simulation specific to the system is not practical. Instead, the simulation combines a MATLAB/Simulink actuator simulation with a readily available C++ dynamics library. This multi-platform approach results in additional incurred challenges due to the transfer of data between the platforms. As a result, the system developed here is designed in the fashion that provides the best balance of realistic behavior, model integrity, and practicality. An analytically derived actuator model is developed using classical fluid circuit modeling together with nonlinear area and pressure curves to model the valve and a Stribeck-Tanh model to characterize the effects of friction on the cylinder. The valve model is designed in Simulink and validated on a single degree-of-freedom test rig. This actuator model is then interfaced with SrLib, a dynamics library that computes dynamics of the robot and interactions with the environment, and validated through comparisons with a CRR prototype. Conclusions are focused on the final composition of the simulation, its performance and limitations, and the benefits it offers to the system as a whole.