Title:
Copper Levels in Drinking Water from Private Household Wells in Major Provinces of Georgia
Copper Levels in Drinking Water from Private Household Wells in Major Provinces of Georgia
Author(s)
Sonon, Leticia
Kissel, David E.
Vendrell, Paul F.
Hitchcock, Rick
Kissel, David E.
Vendrell, Paul F.
Hitchcock, Rick
Advisor(s)
Editor(s)
Collections
Supplementary to
Permanent Link
Abstract
Copper is an essential element in human diet. However, too much copper in drinking water can cause flavor changes and health hazards. Thus, the U.S. Environmental Protection Agency (EPA) has set drinking water standards to regulate copper levels in the drinking water supply. Water test results obtained by the Agricultural and Environmental Services Laboratories (AESL) indicated that about 5.6% of the household well waters submitted for analysis contained copper at concentrations above EPA’s primary maximum contaminant level (MCL) of 1.3 mg L-1. Most of these were detected in Sand Hills and Southern Piedmont provinces. Under Georgia conditions, copper occurs in drinking water primarily due to corrosive water and the dissolution of copper plumbing. These corrosive waters were characterized by being soft (hardness <50 ppm), slightly acidic (pH <6.5), and less buffered owing to low alkalinity (<50 ppm CaCO3).
Sponsor
Sponsored and Organized by: U.S. Geological Survey, Georgia Department of Natural Resources, Natural Resources Conservation Service, The University of Georgia, Georgia State University, Georgia Institute of Technology
Date Issued
2007-03
Extent
Resource Type
Text
Resource Subtype
Proceedings