Finite Element Analysis of the Inflatable Re-Entry Vehicle Experiment
Loading...
Author(s)
Li, Lin
Gonyea, Keir C.
Braun, Robert D.
Advisor(s)
Editor(s)
Collections
Supplementary to:
Permanent Link
Abstract
Hypersonic inflatable aerodynamic decelerator technology can enable future missions to
Mars and the outer planets. Such missions require large drag devices to safely decelerate the
vehicle during planetary entry. Key technologies include flexible materials that will protect
the spacecraft from the thermal environment experienced during reentry into the
atmosphere. An improved understanding and predictive capabilities of the decelerator
behavior is necessary prior to flight. Accurate prediction of the decelerator structural
response under various external pressure distributions is necessary through use of modeling
and simulation. In order to validate the predictions obtained from finite element analysis
and computational fluid dynamic analysis, a series of ground and flight tests have been
conducted. Sub-scale models were used for these tests due to the cost and limitations of test
facilities. This investigation models the decelerator configuration with the intent of
constructing less computationally-expensive models to approximate the structural response.
Modeling results are compared with similar results in the literature as well as idealized
closed-form equations. These results include the meridional shell force resultants in the tori,
spars, and restraint wrap fore and aft side. Due to symmetry, a three dimensional, 15° wedge
model and a two dimensional, axisymmetric model are used. After the model was developed,
the equilibrium deflected solution and Von Mises stresses were calculated and analyzed.
These results correlated well with the closed-form equations and results from literature. This
investigation demonstrates that sufficient accuracy can be obtained using two-dimensional,
axisymmetric models.
Sponsor
Date
2015-01
Extent
Resource Type
Text
Resource Subtype
Paper
Rights Statement
Unless otherwise noted, all materials are protected under U.S. Copyright Law and all rights are reserved